Ramset Cobra - Fasteners/Loads

FASTENERS/LOADS Your Ramset Cobra tool uses only the Ramset fasteners and loads shown below or listed for the tool in the Product Catalog. Click here for application information: Fastening Applications Never use any other types of fasteners or strip loads in the Cobra tool. Use of other types of fasteners or loads may cause unintentional load discharge, damage the tool, cause poor fastening performance, or create a risk of serious injury to the operator or bystanders. FASTENERS .300 Head Plastic Fluted Drive Pins .145 Shank Diameter in Shank Lengths from 1/2" to 2 1/2" 1/4"-20 Threaded Studs .145 Shank Diameter in Shank Lengths of 1/2" and 1" and thred lengths of 1/2", 3/4" and 1" .300 Head Top-Hat Drive Pins .145 Shank Diameter in SShank Lengths from 1/2" to 1" Conduit Clip Assemblies For 1/2" and 3/4" Diameter Conduit with 1" Pre-Mounted Fastener .300 Head Plastic Fluted Drive Pins With 7/8" Washer .145 Shank Diameter in Shank Lengths from 1" to 3" .300 Head Powerpoint Plastic Fluted Drive Pins .150 Straight Shank in Shank Lengths from 1/2" to 7/8" .150/.180 Stop Shank in Lengths from 1" to 7/8" Ceiling Clip Assemblies Ceiling Clip with 1" or 1-1/4" Pre-Mounted .145 Shank Pin and Ceiling Clip with 1" or 1-1/4" Pre-Mounted .150/.180 Shank Pin Loads Ramset RS 27 strip loads are specially made for use in the Cobra Tool. The power level of the loads is indicated by the number marked on each box, the color of the box and the color on the tip of each load. As the number increases, the power level also increases. Always perform the center punch test described in Safety Instructions to test the base material. Always make a test fastening using the #3, Green, power level first. If more power is required to set the fastener, use the next higher power level until the power level necessary to drive the fastener is reached.